AVR USB JTAG ICE Programmer, Emulator and Debugger

AVR USB JTAG ICE Programmer, Emulator and Debugger
 
  • Product Code: SE-DE01-09-0234
  • Availability: Back Ordered - Available in 8-10 days



Rs.799.00

AVR USB JTAG ICE Programmer, Emulator and Debugger is mainly used to simulate the operation of the chip. It can be used for hardware emulation, such as single-step program execution, set breakpoints, etc., through hardware simulation program which can understand the details of the chip operation.

JTAG ICE supported devices:
ATmega16, ATmega16L, ATmega162, ATmega162V, ATmega165, ATmega165V, ATmega169, ATmega169V, ATmega32, ATmega323, ATmega323L, ATmega32L, ATmega64, ATmega64L, ATmega128, ATmega128L, AT90CAN128.

Features:

  • Metal casing with bright Colors (Colors will be sent randomly)
  • 50CM 10 Pins Cable
  • Over-current protection
  • Wide voltage, down to 3.3V
  • Buffer chip protection
  • This emulator firmware has unlimited upgrades, support latest AVR STUDIO Software .

About JTAG

AVR JTAG  is a complete set of the JTAG interface-based on-chip debugging tools for Atmel’s AVR Studio + iccavr, or WINAVR, support all AVR 8-bit RISC instruction with a JTAG port microprocessor. JTAG interface is a 4-wire test access port (TAP) controller that comply with the IEEE 1149.1 standard. IEEE standards to provide an effective test of the circuit board connection standard methods (boundary scan). Atmel AVR devices have extended support full programming and on-chip debug function.

AVR JTAG emulator used for chip hardware emulation program single stepping, setting breakpoints, hardware emulation can understand the detailed operation of the chip inside the program. AVR JTAG emulator is used to simulate the operation of the chip, and also can chip programming through the JTAG interface (the program into the chip).

Write a review

Note: HTML is not translated!
Bad             Good

Tags: AVR | USB | JTAG | ICE | Programmer

Related Products (3)